Watching David Bombal Lab trying to do same as him in GNS3 but I get invalid input detected error in console, below are his results and his project layout and then mine .
PACKET TRACER / N00b] The show inventory command doesn't work ? : r/Cisco
Solved: Problems configuring NAT on 1920 router with Dual WAN (ADSL) - Cisco Community
Anyone using a MacBook to configure Cisco devices through Terminal or iTerm? : r/networking
CCNA Routing and Switching Study Guide part 2. | Ispiti' predlog Network and System Administration | Docsity
Solved: Invalid input detected at marker when issuing NAT command - Cisco Community
Solved: Invalid input detected after IOS upgrade in console only - Cisco Community
Ciscoデバイスの操作 - Cisco IOS - 編集キーとエラーメッセージ
53302372 config-gns3
Ccna1 V7 Cap 1-3 | PDF | Internet Protocol Suite | Computer Network
The main error messages in CLI | Cisco Basic | N-Study
The main error messages in CLI | Cisco Basic | N-Study
chapter 5 | Networking for home, business or ISP
Invalid input detected at '^' marker. - Cisco Community
Solved III D3.1 D3.2 Write about the IOS commands config t | Chegg.com
Setting packet tracer
asa 5505 - cannot config terminal - invalid input detected at marker - Cisco Community
Ciscoデバイスの操作 - Cisco IOS - 編集キーとエラーメッセージ
Ccna1 V7 Cap 1-3 | PDF | Internet Protocol Suite | Computer Network
cisco2500ルータ
Switch marcos | Marcos Gomes - Academia.edu
invalid input detected at marker (when installing EWC on Catalyst 9115axi-e Access Points) - Cisco Community
Solved 36 What three requirements are defined by the | Chegg.com
Solved] Router SSH Access Via Wi-Fi on IPV6 IFT 266 Introduction to... | Course Hero